GRBL Servo Control
 
Notifications
Clear all

GRBL Servo Control


(@alexs)
New Member
Joined: 9 months ago
Posts: 1
Topic starter  

Hello, this project has been incredibly fun and very informative. I am wondering if anyone has figured out how to actuate a servo using GRBL. From looking at the firmware files I think the GCode commands are M96, M97, and M98, but I can't figure out the correct parameters for the commands. I have the servo connected to the D11 pin on the Mega if that helps. I thought I would see if anyone else had figured that out before I spend hours researching.


   
Quote
Topic Tags
Share: